

Add to Cart
The CA368 smart meter can measure electricity from alternative
power sources such as diesel generator power. It is designed for
dual power source scenarios in those grid-unstable areas. . It is a
BS footprint and three-phase four-wire meter that can bear 10 A to
100 A current. The voltage of each phase is 230V (60% 120% Un).
Furthermore, the CA368 is designed as an STS keypad prepaid meter,
operating the prepaid function based on the 20-digit STS Token. The
meter will shut off the power automatically when the user consumes
all credits in it.
Built-in RF communication modules for the CA368 will allow it to
support the development of an AMR management system. The data
concentrator collects data from nearby RF three-phase prepaid smart
meters by RF communication and then uploads the data to our cloud
server by GPRS. You can remotely read and monitor the meters and
switch on/off the relay.
Main Features
>• >Compliant with STS (Standard Transfer Specification)
>• Com port for IR optical & RS485
>• >Automatic disconnection when Credit is used up
>• Flexible >Power limit and low credit warning configuration.
>• >Tamper detection and event recording such as opening cover, reverse
connection, black-out
>• >Dual power source working on both prepayment and credit mode
>• >Maximum demand measurement and load profiling (on request)
User Benefit
>• BS footprint, easy to install
>• >Low operational and maintenance cost
>• PLC/ RF/ GPRS/GSM communication for AMR/AM I features on your
request
>• >Meter provides various valuable information by punching in Calin's
shortcodes
Specifications:
Electrical parameters: | |
Nominal voltage Un | 3x240V |
Limited voltage | 60%~120%Un |
Frequency | 50/60Hz+5% |
Basic current(Ib) | 10A |
Maximum current(Imax) | 100A |
Starting current(Ist) | 30mA |
Active energy constant | 400imp/kWh |
Accuracy | |
Active energy to IEC62053‐21 | Class1.0 |
Reactive energy to IEC62053‐23 | Class2.0 |
Power Consumption | |
Power consumption in Voltage circuit | <2W <8VA |
Power consumption in current circuit | <1VA |
Temperature range | |
Operation meter | 25℃ to+70℃ |
Storage | 40℃ to+85℃ |
Insulation strength | |
AC Insulation strength | 4kV at 50Hz during 1min |
Impulse voltage 1.2/50μs mains connections | 8kV |
Electro Magnetic Compatibility | |
Electrostatic discharges | |
Contact discharge | 8kV |
Air discharge | 16kV |
Electromagnetic RF fields | |
27MHz to 500MHz typical | 10V/m |
100kHz to 1GHz typical | 30V/m |
Fast transient burst test | 4kV |
Mechanical requirements | |
Protection Rating | IP54 |
Insulation Classification | Protective Class II |
Maximum cable size | 10 mm |