

Add to Cart
Video: https://www.youtube.com/watch?v=JWOI-ehVvXs
Support IC type | Module in LedEdit software | Pixel numbers | remark |
LPD6803,D705,1101,6909, 6912 | T-1000-6803 | 2048 pixel | |
LPD8806,LPD8809 | T-1000-8806 | 2048 pixel | |
TM1803,TM1804,TM1809,TM1812 | T-1000-TM | 2048 pixel | TM1804 and TM1809 low speed and high speed |
TM1903TM1904TM1909TM1912 | T-1000-TM19 | 2048 pixel | |
UCS6909UCS6912UCS7009UCS5903 | T-1000-UCS-32 | 2048 pixel | |
UCS1903UCS1909UCS1912 | T-1000-UCS-256 | 2048 pixel | low speed and high speed |
UCS3903 | T-1000-UCS-1024 | 2048 pixel | |
DMX512 | T-1000-DMX | 170/512 pixel | Compatible DMX512 |
WS2801,WS2803 | T-1000-WS | 2048 pixel | |
WS2811 | T-1000-WS2811 | 2048 pixel | low speed and high speed |
DS189 | T-1000-DS189 | 2048 pixel | |
TLS3001,TLS3002TLS3008 | T-1000-TLS | * pixel | |
P9813 | T-1000-P9813 | 2048 pixel | |
SM16715 | T-1000-SM16715 | 2048 pixel | low speed and high speed |
SM16716 | T-1000-SM16716 | 2048 pixel | |
BS0901,BS0902 | T-1000-0901 | 2048 pixel | |
BS0815 | T-1000-0815 | 2048 pixel |
Note:
Controller on the SD card can not be hot-swappable, plug the SD
card every time, you must first disconnect the power supply
controller
Question 1: After power, the T-1000 ERROR indicator has been
flashing without display output
Answer: The ERROR indicator has been flashing means the controller
did not read the card correctly, possible problems:
a .SD card is empty, with no effect file
b .The effect file in the SD card and the controller model are not
match, please choose correct controller model in LedEdit and then
re-create the effect file led
c .SD card did not format to FAT before copy effect files
d .Please check the supply power voltage, the controller can be
individually powered to exclude power reasons
f .Changing the SD card and then test to exclude the possibility of
a bad SD card
Question 2: The controller is powered on, the indicator is normal,
but no effect change in lighting
Answer: The reasons for this are as follows:
A. Check if the lighting′s signal line and the controller connected
correctly
B.If the TTL signal is received, the lamp and the controller must
be common ground, that means connect the lighting′s and the
controller′s ground together
C.check if the model chose during making display files on the SD
card match the chips used in the lighting