PIC12F675-I/SN Electronic IC Chips microchips and integrated circuits

Stock Offer (Hot Sell)

PIC12F629/675

8-Pin, Flash-Based 8-Bit CMOS Microcontrollers

High-Performance RISC CPU:

• Only 35 Instructions to Learn

- All single-cycle instructions except branches

• Operating Speed:

- DC – 20 MHz oscillator/clock input

- DC – 200 ns instruction cycle

• Interrupt Capability

• 8-Level Deep Hardware Stack

• Direct, Indirect, and Relative Addressing modes

Special Microcontroller Features:

• Internal and External Oscillator Options

- Precision Internal 4 MHz oscillator factory calibrated to ±1%

- External Oscillator support for crystals and resonators

- 5 μs wake-up from Sleep, 3.0V, typical

• Power-Saving Sleep mode

• Wide Operating Voltage Range

– 2.0V to 5.5V

• Industrial and Extended Temperature Range

• Low-Power Power-on Reset (POR)

• Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)

• Brown-out Detect (BOD)

• Watchdog Timer (WDT) with Independent Oscillator for Reliable Operation

• Multiplexed MCLR/Input Pin

• Interrupt-on-Pin Change

• Individual Programmable Weak Pull-ups

• Programmable Code Protection

• High Endurance Flash/EEPROM Cell

- 100,000 write Flash endurance

- 1,000,000 write EEPROM endurance

- Flash/Data EEPROM Retention: > 40 years

Low-Power Features:

• Standby Current: - 1 nA @ 2.0V, typical

• Operating Current:

- 8.5 μA @ 32 kHz, 2.0V, typical

- 100 μA @ 1 MHz, 2.0V, typical

• Watchdog Timer Current

- 300 nA @ 2.0V, typical

• Timer1 Oscillator Current:

- 4 μA @ 32 kHz, 2.0V, typical

Peripheral Features:

• 6 I/O Pins with Individual Direction Control

• High Current Sink/Source for Direct LED Drive

• Analog Comparator module with:

- One analog comparator

- Programmable on-chip comparator voltage reference (CVREF) module

- Programmable input multiplexing from device inputs

- Comparator output is externally accessible

• Analog-to-Digital Converter module (PIC12F675):

- 10-bit resolution

- Programmable 4-channel input

- Voltage reference input

• Timer0: 8-Bit Timer/Counter with 8-Bit Programmable Prescaler

• Enhanced Timer1:

- 16-bit timer/counter with prescaler

- External Gate Input mode

- Option to use OSC1 and OSC2 in LP mode as Timer1 oscillator, if INTOSC mode selected

• In-Circuit Serial ProgrammingTM (ICSPTM) via two pins

Absolute Maximum Ratings†

Ambient temperature under bias................................................................................... -40 to +125°C

Storage temperature ................................................................................................ -65°C to +150°C

Voltage on V_DD with respect to V_SS ............................................................................... -0.3 to +6.5V

Voltage on MCLR with respect to Vss ............................................................................-0.3 to +13.5V

Voltage on all other pins with respect to V_SS .................................................... -0.3V to (VDD + 0.3V)

Total power dissipation⁽¹⁾ ........................................................................................................800 mW

Maximum current out of V_SS pin .............................................................................................. 300 mA

Maximum current into V_DD pin ................................................................................................. 250 mA

Input clamp current, I_IK (V_I < 0 or V_I > V_DD)...............................................................................±20 mA

Output clamp current, I_OK (Vo < 0 or Vo >V_DD) ........................................................................±20 mA

Maximum output current sunk by any I/O pin............................................................................... 25 mA

Maximum output current sourced by any I/O pin ......................................................................... 25 mA

Maximum current sunk by all GPIO ............................................................................................ 125 mA

Maximum current sourced all GPIO ............................................................................................ 125 mA

Note 1: Power dissipation is calculated as follows: PDIS = VDD x {IDD - ∑ IOH} + ∑ {(VDD-VOH) x IOH} + ∑(VOl x IOL).

Pin Diagrams

King--- Originator of ANTERWELL, engaged in the IC electronics industry in 1998 and establish ANTERWELL in 2004. The company is located in Shenzhen Huaqiang North, the largest electronic center in Asia. Our main business is the technical development and electronic products import and export business. Currently, we have branches in Hong Kong and Malaysia.

Up to now. ANTERWELL have more than 1,000,000 types of electronic components in stock. ANTERWELL has become one of the top choices for purchasing IC chips both domestically and internationally. King is a senior IC chip expert, sales engineer, and mentor, leading an elite team with customer first, quality first, honesty, trustworthiness, and mutual benefit. We look forward to cooperate with you to create a better future!

ANTERWELL’s main products include semiconductors, resistors, capacitors, diodes, inductors, connectors, transistors, sensors, etc. Involving the major well-known brands such like: TI, XILINX, FAIRCHILD, STM, MICRON, MICROCHIP, TDK, SAMSUNG, ON, NXP,IR,ADI, ATMEL,VISHAY,LINEAR etc.

ANTERWELL adheres to the development concept and purpose of "direct stock offer, excellent quality, favorable price, and sincere service", which is deeply recognized by domestic and foreign customers. Based on the long-term development goal, ANTERWELL provides customers with standardized, professional, and diversified high-quality services through a strong market service network. ANTEWRELL has multiple skilled and capable executives with a professional QC team and excellent sales team to win the high support and trust of the vast customer base! We provide the best quality, price and service.

ANTERWELL will be your best Partner.