

Add to Cart
Filter out the impurities and suspended matter in the water to
ensure that the water is clean and sanitary and will not cause
blockage. Screens are typically made of fine-mesh stainless steel
mesh that effectively removes sediment, sediment, and other small
particles from the water. The design and placement of wire-wound
screens can be adjusted to ensure a balance between water flow and
filtration.
Slit vibrator is composed of a set of cylindrical shaker with
straight equipment. There is a bias block or a bias wheel at both
ends of the cylindrical shaker. When the motor drives the bias
wheel to rotate, centrifugal force occurs and is transmitted to the
equipment on the main shaft in the cylinder, so that the main shaft
moves in a circle around the center line fixed on it. Thus, the two
supporting rings fixed at both ends of the spindle roll along the
axis direction.
Because the two supporting rings are located in opposite directions
of the roll and parallel to each other, a gap is formed between
them parallel to the horizontal plane. When the material enters
from the feed end, it falls into the lower discharge port through
the gap, and the other part of the material is discharged from the
discharge port and discharged out of the machine through the
discharge tank.
The working principle of the seam screen: when the motor drives the
biased wheel clockwise rotation by the coupling, the centrifugal
force drives the equipment at both ends of the vibrator to the
opposite direction along the axis of the support ring light, at the
same time installed in the rotor above the two isolation tautts
also follow the rotation of the rotor and contraction deformation,
So the whole rotor is moving back and forth along a sinusoidal
track at a certain point of view to the horizontal plane.
Specificarion:
MaterialA | Stainless steel |
Grade | 304 |
O.D | 219mm |
Size | 8" |
Length | 300mm-6000mm,2.9m,5.8m |
Solt size | 1.0 mm |
End connection | Thread Couplings ( male / female ) |
Wire size | 93 # |
Support rod | 140 # |
Wire shape | V shape |
Not easy to jam
the special V shaped wire, make the hole of screen outside face is smaller than inside, so the hole is not easy to jam.
Slot even
The CNC machine tools strictly control the gap between the wire, so that the gap is even.
Strong corrosion resistance
Stainless steel 304 have the high corrosion resistance
Regular Specification:
Material: Stainless steel 304, 304L, 316, 316L, 321. Low Carbon Steel Galvanized
Diameter: 30 - 1000mm, such as 63mm, 89mm, 117mm, 168mm, 219mm, 273mm, 325mm, 377mm and so on.
Inch: 3 " , 4 " , 6 " , 8 " , 10 " , 12 " , 14 " , 16 " and so on.
Length: 2.9m and 5.8m is the regular length ,and we can make the length 300mm - 6000mm.
Slot size: 0.2mm , 0.5mm , 0.7mm , 1.0mm , 1.5mm. 0.1 - 45mm.
End connection: welded rings, thread couplings ( male / female )
V wire: 63 #, 93 #, 118#, and so on.
Support rod : diameter 300mm, 350mm, 380mm, 400mm, 480mm, 500mm and so on.
We can make the screen pipe as the customers' requested!
Use:
Johnson wire wrap screen is manufactured with V-shaped profile wire which is spirally wound around a cage of longitudinal support rods. Each intersecting point of these wires is fusion welded. The pitch of winding gives different spacing between two adjacent turns of wire. This spacing gives passage for water to enter. The entire process is completed on fully computerized machines.
Pictures: