3D Protection WECO Door Sensors Used In Elevators AC220 CE CSA Approved

Brand Name:WECO
Certification:CE CSA
Model Number:WECO-957MD-3D
Minimum Order Quantity:5PCS
Delivery Time:15Workdays
Payment Terms:T/T, Western Union, MoneyGram
Contact Now

Add to Cart

Active Member
Location: Ningbo Zhejiang China
Address: NO. 51 LONGTANSHAN ROAD, BEILUN, NINGBO, 315806, CHINA
Supplier`s last login times: within 1 hours
Product Details Company Profile
Product Details

3D Protection WECO Door Sensors Used In Elevators AC220 CE CSA Approved

Introduction
Ningbo WECO Optoelectronics CO., LTD. developed to produce WECO Brand elevator door detector with more than 15 years. The light curtain is adopting infrared light reflecting principle, when elevator doors are interrupted by obstructions, a signal will be sent out from door detectors, door operators will receive this signal and control the door opening. With advanced production management and strict quality inspection, WECO door detector has become the first brand in the world, providing reliable guarantee of passengers’ safety.


WECO-957MD-3D is an upgrade model compare to parted 3D sensor, which is applied to high-end occasions.

Advantages
3D protection, detected to the stereoscopic area
Easy Installation, same as common products.

Application
All type elevator

Features

Technical FeatureWECO-917MD-3DWECO-957MD-3D
Number of Infra Red Diodes32 Diodes
Response TimeRelay output61ms
Transistor output37ms
Sacanning Beams154-94 beams
Detecting Height20~1840mm
2D detecting Range0~4m
Light Immunity100000Luxsunlightproof
Operation Temperature-20℃-+65℃
Protection LevelIP54
EN12015, EN12016General Circuit Level
Voice Reminderafter continuous detection for 15s, buzzer ON.
LED Interpretation1. Yellow LED and Red LED in Receiver on when blocked or in malfunction.
2. Yellow LED in receiver on and Red LED in receiver off without blocking.



Installation dimension



LED Indicator Function


Installation
1. The door detector should be installed on both side of car door, as close to the forward edge of the car door in order to prevent the infrared being obstructed by the landing door and shoot out with the angel of 45°.
2. During the installation make sure the two sides are in a same hotizontal up and down. Power ON after installation.
3. Ensure there are no obstalces in front of the landing door, make a round closing and opening several times by manual operating and observe if the process goes smoothly.
4. Keep the elevator in the same leveling position. Do 3D self- learning configuration. Two sensitive range for your choices.
5. Factory reset: ( only do this step if you want to back to factory setting, otherwise go to step 6). Power off the dorr detector, turn the switch 4 to ON, then power on the door detector, the device is entering the factory reset, wait 1s when hearing the buzzer beep, turn the switch 4 to OFF, door detector back to normal state.
6. Normal running stute.
Keep all switches to OFF, let the door detector back to normal state.

Shipping

1) By Express (3-7 working days), suitable for Small Quantity.

2) By Sea (15-30 days), suitable for regular Mass Production.

3) By Air (4-5 days), from Airport to Airport, suitable for Urgent orders.




































China 3D Protection WECO Door Sensors Used In Elevators AC220 CE CSA Approved supplier

3D Protection WECO Door Sensors Used In Elevators AC220 CE CSA Approved

Inquiry Cart 0