

Add to Cart
Commercial Two Stage Reverse Osmosis Drinking Water Purification System
Introduction
Two-stage RO system is widely used in preparation of water for
beverage industry, which features adaptable of different salt
content of water, easy operation, less labor force and low running
cost.
Composition
1. Pre-treatment System.
Pre-treatment system is composed of quartz sand filter, active
carbon filter, softener and precision filter. The water temperature
requires
25± 30C.
Flocculator is used for destroying electro-neutral of colloid in
water, which ensures raw water can reach to the requirement of Silt
Density Index(SDI)≤ 4. Mechanical filter can remove most of
suspension, colloid and grain impurity, which can ensure initial
purification of water.
If some of raw water comes from tap water, chlorine content maybe
is higher. Low-pressure compound RO membrane has strict limitation
to chlorine and organism, which must be ≤ 0.1mg/1.
Because calcium and magnesium content in raw water is very high,
and RO salt-removing rate is about 97%, which may cause deposit of
calcium carbonate, magnesium carbonate, bitter salt, etc. On
concentrated water side. Deposit adhered on RO membrane surface and
may block passage of components and causes pressure difference
increase, water output decrease and salt-removing rate decrease,
which influences normal running and usage span of RO. So before
precision filter, Scale Inhibitor is equipped to protect and avoids
impurity on RO concentrated water side.
2. Reverse osmosis System
RO system is composed of high-pressure pump, two-stage RO system
and chemical cleaning device.
two-stage RO system can remove salt over 99% and 100% organisms.
During running, RO membrane may form some deposit and chemical
cleaning device is equipped for periodical cleaning to ensure
stable running of RO system. This system configures with
Hydranautics ESPA1 membrane compounds (USA) and Grundfos
high-pressure pump (Denmark).
High-pressure pump is the power source of RO system. To RO system
on sound running condition, high-pressure pump equips inlet/outlet
pressure switch. When inlet pressure is less than set value (water
lack P≤ 0.05Mpa) or outlet pressure is higher than set value,
pressure switch send signal to PLC programming system and
high-pressure pump and RO system will stop in avoidance of
destroying to RO membrane because of water pressure.
RO system pressure control and automatic cleaning are controlled by
PLC. RO system can wash surface of RO membrane by low-pressure
timely and periodically.
This water treatment capacity is 10 m3/h. Salt-removing rate is
over 99.0% and water recycling rate is 75%.
Specifications
No. | Name / Specification | Unit | Qty. |
1. Technical Equipments | |||
1 | Raw Water Tank Vn=5m3 | unit | 1 |
2 | Raw Water Pump | unit | 1 |
3 | Mechanical Filter | unit | 1 |
4 | Active Carbon Filter | unit | 1 |
5 | Softener | unit | 1 |
6 | Precision Filter | unit | 1 |
7 | 2-stage RO System | unit | 1 |
8 | Central Water Tank | unit | 1 |
9 | Pump | unit | 1 |
10 | Oxidation Tower | unit | 1 |
11 | Ozonizer | unit | 1 |
12 | Pure Water Tank | unit | 1 |
13 | Pump | unit | 1 |
14 | Ti-rod Filter | unit | 1 |
2. Material | |||
Refined Sand 0.4-0.6mm | ton | ||
Active Carbon 0.6-0.8mm | ton | ||
Positive Resin 001& times; 7 | ton | ||
3. Pipelines and Valves | set |