

Add to Cart
Custom 12V Rechargeable Battery Pack UPS Power Safe Battery Lithium 12V 100Ah
Possible dangers
Risk of short circuit and the subsequent fire
Charged and uncharged cells contain large amount of electricity,
which can cause a short-circuit in the electrical spark or arc. The
battery itself is not combustible, but from incandescent contacts
may ignite other combustible materials.
Risk of injury by DC
When connecting more cells and batteries in series increases the
risk of injury DC. In any case, do not touch electrical wires or
other components under voltage.
Risk of chemicals
Lithium cells and batteries contain no caustics and acids. However
contain chemical substances, that act on the human body. For this
reason, in the handling of cells and batteries must observe the
following rules:
Eye protection: protect your eyes with goggles against the ingress
of chemicals in the eye.
Skin protection: wear protective clothing and gloves. Avoid skin
contact with chemicals.
Protection against inhalation: Operate with batteries only in
well-ventilated areas. In enclosed spaces it is necessary to
provide forced air ventilation.
Charging
warning
WARNING: Carefully check the maximum voltage as specified cells or
batteries. Exceeding the voltage will damage the battery and void
the warranty.
Initial charging
New batteries LFP/LFYP are partly charged from factory. However,
before first use it is absolutely necessary to charge the battery
to full capacity. This initial charging should be done at maximum
current of 1C and the voltage level according to the specification
of the cell or battery. Please see specifications of the cell about
value of initial charging. Battery capacity in the first cycle
gradually grows. In the first few cycles is recommended to avoid
rapid discharge to the minimum capacity and we do not recommend
quick charging. After about the fifth, sixth cycle, is nothing to
prevent the batteries used in full operating cycle according to the
manufacturer's specifications for the type of battery.
Standard charging
Because LiFePO4 batteries has no memory effect, charging can be
done at any time. Repeated short charge cycles the battery life not
significantly changed (within + / - 5%).
Discharging
warning
WARNING: Carefully check the minimum voltage as specified cells or
batteries. Discharging below this voltage will damage the battery
and void the warranty.
Maximum discharging currents for single cells or batteries are
listed in the manufacturer's specifications for the type of cell.
Battery and cell checking
Battery check and match any individual cell or battery is done by
charging the cells in series, connecting the charger to each
individual battery. Checking the battery status and any match is
recommended to perform these intervals (ie, discharge / charge
cycle):
first charge
after the first cycle
after the 5 cycles
after the 20 cycles
after the 50 cycles
possibly followed by further the anomalies detected about once
every 50 to 200 cycles
BMS
Each Battery a built-in BMS. This BMS is a high-tech design that
manage two main aspects of battery during operation :Protection
features :
Low Voltage Protection Switch – Automatically disconnects at 10.0V
Over Voltage Protection Switch – Automatically disconnects at 15.0V
Specifications | Battery Lithium 12V 100Ah |
Cells | 3.2V 100Ah Sinopoly Prismatic Cells |
Power | Customized |
Nominal capacity | 100Ah |
Nominal voltage | 12.8V |
Size and Weight | 350(W)x270(H)x155mm(W) |
Charge Temperature Range | 0-45C |
Discharge Temperature Range | -20-60C |
PCM/BMS | Including and Accept to OEM/ODM |
Case | ABS Case |
Charging cycles | +2000 times |
Application | Motorcycle,golf cart.Power supply ,Solar system |
Features | Small Volume,Long Cycle Life, High Safety,Environmental Protection |