6AG1972-0BA12-2XA0 Bus Connector Profibus Dp RS 485 Easy Installation

• Used for connecting PROFIBUS nodes to the PROFIBUS bus cable
• Easy installation
• FastConnect plugs ensure extremely short assembly times due to their insulation-displacement technology
• Integrated terminating resistors (not in the case of 6ES7 972-0BA30-0XA0)
• Connectors with Sub-D socket permit PG connection without the additional installation of network nodes

Several different versions of the bus connector are available, each optimized for the devices to be connected:

• Bus connector with axial cable outlet (180°), e.g. for PCs and SIMATIC HMI OPs, for transmission rates up to 12 Mbps with integrated bus terminating resistor.
• Bus connector with vertical cable outlet (90°);

This connector permits a vertical cable outlet (with or without PG interface) for transmission rates of up to 12 Mbps with integral bus terminating resistor. At a transmission rate of 3, 6 or 12 Mbps, the SIMATIC S5/S7 plug-in cable is required for the connection between bus connector with PG-interface and programming device.

• Bus connector with 30° cable outlet (low-cost version) without PG interface for transmission rates of up to 1.5 Mbps and without integrated bus terminating resistor.
• PROFIBUS FastConnect bus connector RS 485 (90° or 180° cable outlet) with transmission rates up to 12 Mbps for fast and easy assembly using insulation displacement connection technology (for rigid and flexible wires).

Function

The FastConnect stripping method enables fast and easy connection of PROFIBUS connectors to the PROFIBUS cables.

The special structure of the FastConnect bus cables enables the use of the FastConnect stripping tool with which the outer casing and the woven shield can be stripped in one operation with perfect precision. The cable prepared in this way is connected in the FastConnect bus connector using the insulation displacement method.