Domestic Din Rail Surge Suppressor , Overvoltage Protection Din Rail Surge Protector

Network device, power supply, lightning protector, signal protector, two in one protector.

Product introduction

Surge protector is an electronic device that provides security protection for all kinds of electronic devices, instruments and communication lines. It is applied to the power supply system with AC 50/60HZ and rated voltage to 380V, to protect indirect lightning and direct lightning effects or other transient overvoltage surges.
It is suitable for household housing, the third industry and the demand for the electric surge protection in industry. It has relative, relative, relative middle line, middle line to ground and its combination protection mode.

Working principle of product

The working principle of surge protector is a high resistance open state with a low voltage, low resistance and short circuit state at high pressure, and a combination of over voltage protection electronic devices which can withstand hundreds of amperes and large current in parallel on the power supply line and signal transmission line. When encountering lightning and high voltage and high current, it will appear short circuit immediately, and at the same time, the total power switch will be disconnected, so that the device will be protected.

Notice of product

1. standard RJ45 interface can be conveniently connected to the front end of the protected equipment. The grounding path should be as short as possible, and the length should not exceed 1.5 meters.

2. connect the grounding wire of the lightning protector with the ground wire of the lightning protection system.

3. this product needs no special maintenance. The lightning arrester should be checked regularly, especially in the thunderstorm season and the whole thunderstorm period. When the system fails to suspect the lightning arrester, the lightning arrester can be dismantled and rechecked. If the system is restored to normal after the restoration to the state before use, the lightning arrester has been damaged and must be replaced immediately.

Product features

1. with the power status indication, indicating the working state of surge protector.

2. module is designed and installed conveniently and can be replaced directly.

3., new technology, high energy, gap discharge electrode N-PE.

Product specification

Product Installation

With 35mm standard DIN-rail mounting, connecting copper stranded conductor is 2.5~35mm²

At front of spd each pole must be setted protection---used fuse or miniature circuit breaker lightning current SPD protection,after SPD breakdown to short circuit protection.

SPD install on protected line(equipment) to the front and connected to the supply line. A class products install in the building home-entry line hold larger surge current total distribution box. B, C class products most install on the floor distribution box, D class products close to the front-end equipment that smaller surge current, smaller residual voltage place.

Company profile

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.

Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built everything to offer a wide range of innovative and reliable surge protection solutions and products.

Thor is following the international quality system standards, is ISO 9001 certified and our technical standards are in line with GB18802.1-2011/IEC61643-1.

All types and classes of our lightning and surge arresters 20KA~200KA(8/20μS) and 15KA~50KA(10/350μS) are tested and pass all the requirements based on their class.

Thor has been designing new products to meet the RoHS directive since 2006. Thor’s ongoing commitment to RoHS compliance includes continuing efforts to reduce the presence of hazardous substances in the design and manufacture of a growing number of popular products.

Zhejiang Thor Electric Co., Ltd is committed to meeting the requirements of the European Union’s Waste Electrical and Electronic Equipment (WEEE) directive. This directive requires producers of electrical and electronic equipment to finance the take-back for re-use or recycling of their products placed on the EU market after 2005.