Solid High Rise Lightning Protection Rod Home Arrester With Superior Conductivity

High rise building grounding pin, lightning rod, home arrester, engineering lightning protection.

Brief introduction

The lightning rod product is designed according to the standard of the GB national standard. Using advanced active energy pilot discharge technology, the lightning rod can actively monitor the change of the electric field around the surrounding area. By the forced discharge, it can actively accelerate the downlink pilot. Under the same height, the protection scope of the lightning rod is larger than that of the traditional lightning rod, and the flash is more accurate.

Working principle of product

lightning rod is connected to the ground through the wire and forms the equal potential difference with the ground. Using its own height, the electric field of the lightning cloud is distorted to increase the electric field intensity to the limit value. The lightning rod begins to ionize and descends the pilot discharge; the lightning rod produces the tip discharge under the action of the strong electric field, and forms the upward pilot discharge; both are converge to form the lightning passage. Then, it goes into the earth to achieve the effect of lightning protection. In fact, the lightning rod is a lightning needle, which can lead the surrounding lightning and discharge ahead of time and pass the lightning current through its own grounding conductor to the ground, avoiding the direct lightning strike of the protection object.

Product features

1. superior conductivity

2. the lightning flow rate is large and the attenuation ratio is high

3. installation is simple, solid and reliable

Product specification

Use of attention

1. lightning rod grounding wire must be connected to the earth reliably

2. check regularly whether the connection points of the bolts are firmly grounded, and whether the lead off line is connected with the grounding system reliably.

3. during installation, all parts must be connected reliably. After installation is completed, there is damage on the joints or metal surfaces, and rust treatment shall be done.

4. the lead off line should be broken card and insulation protection near the ground.

Company profile

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.
Ltd is committed to meeting the requirements of the European Union’s Waste Electrical and Electronic Equipment (WEEE) directive. This directive requires producers of electrical and electronic equipment to finance the take-back for re-use or recycling of their products placed on the EU market after 2005.

Product packaging:Carton packing

Transportation method

2. Trains, ships, aircraft transport

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.

Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built everything to offer a wide range of innovative and reliable surge protection solutions and products.

Thor is following the international quality system standards, is ISO 9001 certified and our technical standards are in line with GB18802.1-2011/IEC61643-1.

All types and classes of our lightning and surge arresters 20KA~200KA(8/20μS) and 15KA~50KA(10/350μS) are tested and pass all the requirements based on their class.

Thor has been designing new products to meet the RoHS directive since 2006. Thor’s ongoing commitment to RoHS compliance includes continuing efforts to reduce the presence of hazardous substances in the design and manufacture of a growing number of popular products.

Zhejiang Thor Electric Co., Ltd is committed to meeting the requirements of the European Union’s Waste Electrical and Electronic Equipment (WEEE) directive. This directive requires producers of electrical and electronic equipment to finance the take-back for re-use or recycling of their products placed on the EU market after 2005.