Smart Cabinet Power Distribution Unit , Surge Protector Socket High Performance

The PDU cabinet power socket with switch socket thread hole 8 lightning protection socket

Product introduction

The PDU series cabinet type power protection lightning protection device is designed according to the IEC standard. It is specially designed for the sensitive equipment for the fine protection of single-phase AC power supply. It is applied to the equipment end as the third level protection of the power supply, so that the equipment is protected from the transient overvoltage caused by lightning or electronic interference. The power protection lightning arrester adopts two cascade linkage protection, the maximum flow rate can reach 20kA, the voltage protection level can be as low as 800V, the input and output compatibility of Multi Country standard plugs and various power matching, the restorable overload protection device, and the perfect combination of the lightning arrester and the power supply board. The product is equipped with multiple output socket, compatible with multi - country plug standard, and can protect multiple power supply at the same time. It is safe, reliable, simple and convenient. The replaceable lightning protection module is convenient for maintenance and two development.

Product features

1. with temperature control and overcurrent failure protection circuit, does not affect the normal operation of the line.

2. lightning protection socket is suitable for overvoltage protection of the last stage of the device terminal.

3. lightning protection socket has low residual pressure and large flow capacity

Use of attention

1. when multiple plugs are inserted at the same time, the total power load should not exceed the maximum allowable power.

2. lightning protection socket frame type lightning protection socket press the power switch button, the grounding indicator light (yellow), indicating that the ground is reliable; the work indicator light (green), indicating the normal work of the lightning protection module; the power indicator light (red), indicating the normal connection of the power supply.

3. lightning protection socket should be checked regularly and check whether the indicator is working normally.

Product specification

Working principle of product

The surge protector of PDU lightning protection socket is very high when no voltage is needed, which is equivalent to breaking circuit. When the voltage occurs, the impedance drops to a few Europe, and the surge current will flow through the surge protector and will not enter the device. At the same time, because the surge protector has a small impedance at this time, the voltage on both sides of the surge is relatively small, and because he is in parallel with the protected equipment, it prevents the equipment from suffering from large surge power. Pressure, so as to play the effect of discharge and pressure limiting.

Company profile

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.

Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built everything to offer a wide range of innovative and reliable surge protection solutions and products.

Thor is following the international quality system standards, is ISO 9001 certified and our technical standards are in line with GB18802.1-2011/IEC61643-1.

All types and classes of our lightning and surge arresters 20KA~200KA(8/20μS) and 15KA~50KA(10/350μS) are tested and pass all the requirements based on their class.

Thor has been designing new products to meet the RoHS directive since 2006. Thor’s ongoing commitment to RoHS compliance includes continuing efforts to reduce the presence of hazardous substances in the design and manufacture of a growing number of popular products.

Zhejiang Thor Electric Co., Ltd is committed to meeting the requirements of the European Union’s Waste Electrical and Electronic Equipment (WEEE) directive. This directive requires producers of electrical and electronic equipment to finance the take-back for re-use or recycling of their products placed on the EU market after 2005.