Whole house surge arrester power surge protective 40KA surge protector

Surge protection switch SPD The best product of Thor brand surge protective device

product description

Surge protector lightning protector is used to protect sensitive lines from lightning induction voltage, power grid voltage fluctuation, electrostatic discharge and surge voltage caused by large load start-up.
It is widely used in family housing, third industry and industrial field.

Structure and Principle

SPD is a port, shocking protection, indoor-mounted installation, voltage-limited.

SPD hold disconnector inside, when SPD breakdown failure by over heating, the disconnector can remove from the power grid automatically, and show indication signal. When SPD is working properly, visible window display green, it display red when it breakdown and disconnect.

1P+N,2P+N,3P+N SPD consist of 1P,2P,3P SPD+NPE zero ground protection module, apply to TN-S, TN-C-S and other power supply system.

Product features

1. cut off the line when undervoltage occurs, and reset automatically after restoration.

2. the speed of response is 0.001 seconds, and the voltage is controlled in the range that the equipment can withstand.

3. traffic flow to further improve safety

Product specification

Working principle of product

Surge protector and its voltage limiting functional element are composed of metal oxide varistors in parallel. Each varistor requires an independent disconnector. The principle of the disconnector is a heat release. The function is disconnected through the low temperature welding point and is separated from the metal rod by its own elastic action. After disengagement, the red indication will appear in the transparent window on the front side of the surge protector. It is installed in the main power distribution cabinet and outdoor power distribution cabinet.

Use of attention

1. connect the grounding wire of the lightning protector with the ground wire of the lightning protection system.

2. lightning arresters are connected in series

3. lightning protection device IN as input and OUT as output, the input end is connected with the outside, and the output end of the input end of the connecting device is protected.

Company profile

Zhejiang Thor Electric Co., Ltd is committed to meeting the requirements of the European Union’s Waste Electrical and Electronic Equipment (WEEE) directive. This directive requires producers of electrical and electronic equipment to finance the take-back for re-use or recycling of their products placed on the EU market after 2005.
Incorporated in 2006, Electric Co., Ltd has built everything to offer a wide range of innovative and reliable surge protection solutions and products.

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.

Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built everything to offer a wide range of innovative and reliable surge protection solutions and products.

Thor is following the international quality system standards, is ISO 9001 certified and our technical standards are in line with GB18802.1-2011/IEC61643-1.

All types and classes of our lightning and surge arresters 20KA~200KA(8/20μS) and 15KA~50KA(10/350μS) are tested and pass all the requirements based on their class.

Thor has been designing new products to meet the RoHS directive since 2006. Thor’s ongoing commitment to RoHS compliance includes continuing efforts to reduce the presence of hazardous substances in the design and manufacture of a growing number of popular products.

Zhejiang Thor Electric Co., Ltd is committed to meeting the requirements of the European Union’s Waste Electrical and Electronic Equipment (WEEE) directive. This directive requires producers of electrical and electronic equipment to finance the take-back for re-use or recycling of their products placed on the EU market after 2005.