Add to Cart
Item Specification
Brand Name: Item Specification
Marca:Vekest
DaModelo Número:TTD-100M-S
Fiber transmission distance:20KM
Fiber port:SC type
Max. Data Transfer Rate:10/100M
Wavelength:1310/1550nm
Fiber:Single fiber
Mode:Single mode
Power:5V
Product description
Product introduction
10/100 m Ethernet self-adapting fiber optic transceiver is equipped
with the latest America-made chip and high quality Optic
Transceiver module, so it has stable performance and good quality.
It applies to communication, Broadcasting and television and
broadband networks as well as general optical networks which
require high performance and reliability.
Product characteristics
* 1 RJ45 electrical port and 1 SC optical port, capable To realize
optical-to-electrical signal conversion between twisted pair and
fiber optic
* Meet IEEE802.3 10Base-T, IEEE802.3u standards 100Base-TX and
100Base-FX
* Has 10 m / 100 m self-adaptive capacity, and manual adjustment is
unnecessary
* The port supports Full-automatic electric cross-identification,
and switch does not need to be manually operated
* Full-Duplex / Half-Duplex Support Operation Mode
* IEEE802.3X full-duplex and half-duplex flow control support for
back pressure flow control
* Support anti-function Broadcast Storm
* Built-in anti-lighting circuit can significantly reduce the
damage caused by induction rays
* 6 LED indicator lights: Power, TX 100, TX link / Act, FX 100, FX
Link / Act, E FDX / col, convenient to monitor the operation status
of the transceiver and judge fault cause
* The divergent angle of light emergence: equal to or greater than
10dB
* Power supply: External AC 220 V (90-265 V), internal DC 5 V 1A
* Voltage: DC 5
* Power: 8 W, up to Carrier-Class operating standards
* MTBF is more than 50 thousand hours
* Product size: 10 (cm) * 7.5 (cm) * 2.6 (cm)
* Package size: 23 (cm) * 12 (cm) * 5.5 (cm)
Light Indicator Description
Indicator Light
state
Work situation
PWR
In
Switched on
Out
Off
SD Optical gateway
Usually in
Stable optical signal input
Out
No optical signal input
Shimmering
Is there any optical signal but is not stable
FX Link / Act
Usually in
Optical signal is turned on, but there is no data exchange
Shimmering
There is data exchange
Out
Fiber optic is extraneous