6T Lorry Mounted Crane Hydraulic Power With Air Brake

6 ton truck crane

1. Chassis: special chassis for Jianghuai truck crane.

2. Engine: Guowu Yuchai 160hp yc4e160-56

3. Tire: 1000r20 steel wire tire

3. Brake: air brake

4. Direction: hydraulic power

5. Wheelbase: 4500mm

6. Maximum speed: 90km / h

7. Single arm length: 8M

8. Number of boom sections: 5

9. Boom structure: internal rope

10. Size of heavy section boom: height: 58cm, width: 48CM

11. Number of lifting legs: 5 (two legs on each side, with auxiliary rear legs)

12. Side outrigger structure: double leg, single leg span 2m (from the body)

13. Outrigger span: 6.4m; longitudinal span: 5m

14. Hydraulic system: three pump combined system

15. Fan heating system: air cooling fan heating system

16. Motor: 18.5kw

17. Double Winch: double bent plunger motor hydraulic winch

18. Large frame structure: I-beam steel box large frame

19. Torquer

20. Appearance dimension: 11280mm long, 2480mm wide, 3260mm high

21. Total mass: 17500kg

TIANJIN COMMAND MACHINERY MANUFACTURING CO.,LTD Thank you for your attention and support!

Our company specializes in the production of water well drilling rigs (rotary table, power head), which can meet the requirements of technology: 1 positive mud circulation, 2 reverse mud circulation, 3 air DTH hammer, 4 air lift reverse circulation (without complete crushing, improve drilling efficiency), 5 Hydraulic DTH hammer (without air compressor), engineering drilling rig, agricultural machinery and other mechanical equipment. Committed to providing users with the most suitable equipment for practical use, and has strong design capabilities. Individual product customization can be implemented without any additional charges. We insist on comparing with similar products at home and abroad, and always ensure the advanced nature of our products.

A good product is not necessarily the most technological and advanced, but it must be the most in line with the actual needs. To make this product, we can not rely solely on designers. We know this well, so we have two groups of design teams for the product. A group of after-sales engineers with more than 30 years of domestic and foreign construction experience, and a group of designers with rich working experience graduated from well-known colleges and universities, which are based on professional division of labor (mechanical design and manufacturing and automation, material forming, mechanical and electronic engineering, manufacturing engineering, etc.). We will combine the rich practical construction experience and the most top professional theoretical knowledge to meet your various needs.

We are not only familiar with the products, but also familiar with the human environment, construction environment and stratum of domestic and foreign construction areas. We can provide you with all-round product selection suggestions and product customization. To provide you with the greatest technical support to help your cause take off.