TCA9406DCUR TCA9406YZPR Programmable Logic ICS Voltage Levels Dual Bidirec 1MHz Vltg Lev-Trans

TCA9406DCUR TCA9406YZPR Programmable Logic ICS Voltage Levels Dual Bidirec 1MHz Vltg Lev-Trans

1 Features

• 2-Bit Bidirectional Translator for SDA and SCL Lines in I2C Applications

• Provides Bidirectional Voltage Translation With No Direction Pin

• High-Impedance Output SCL_A, SDA_A, SCL_B, SDA_BPinsWhenOE=LoworVCC =0V

• Internal 10-kΩ Pullup Resistor on All SDA and SCL Pins

• 1.65Vto3.6VonAportand2.3Vto5.5VonB port (VCCA ≤ VCCB)

• VCC Isolation Feature: If Either VCC Input Is at GND, Both Ports Are in the High-Impedance State

• No Power-Supply Sequencing Required: Either VCCA or VCCB Can Be Ramped First

• LowIoff of2μAWhenEitherVCCA orVCCB =0V

• OE Input Can Be Tied Directly to VCCA Or Controlled By GPIO

• Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II

• ESD Protection Exceeds JESD 22

  • – APort

    • – 2500-V Human-Body Model (A114-B)

    • – 250-V Machine Model (A115-A)

    • – 1500-V Charged-Device Model (C101)

  • – BPort

    • – 8-kV Human-Body Model (A114-B)

    • – 250-V Machine Model (A115-A)

    • – 1500-V Charged-Device Model (C101)

2 Applications

• I2C/SMBus

• UART

• GPIO

3 Description

The TCA9406 is a 2-bit bidirectional I2C and SMBus voltage-level translator with an output enable (OE) input. It is operational from 1.65 V to 3.6 V on the A- side, referenced toVCCA, and from 2.3 V to 5.5 V on the B-side, referenced to VCCB. This allows the device to interface between lower and higher logic signal levels at any of the typical 1.8-V, 2.5-V, 3.3-V, and 5-V supply rails.

The OE input pin is referenced to VCCA, can be tied directly to VCCA, but it is also 5.5-V tolerant. The OE pin can also be controlled and set to a logic low to place all the SCL and SDA pins in a high-impedance state, which significantly reduces the quiescent current consumption.

Under normal I2C and SMBus operation or other open-drain configurations, the TCA9406 can support up to 2 Mbps; therefore, it is compatible with standard I2C speeds where the frequency of SCL is 100 kHz (Standard-mode), 400 kHz (Fast-mode), or 1 MHz (Fast-mode Plus). The device can also be used as a general purpose level translator, and when the A- and B-side ports are both driven with push-pull devices the TCA9406 can support up to 24 Mbps.

The TCA9406 features internal 10-kΩ pullup resistors on SCL_A, SDA_A, SCL_B, and SDA_B. Additional external pullup resistors can be added to the bus to reduce the total pullup resistance and speed up rising edges.

Device Information