MT48LC8M16A2P-6A IT:L Integrated Circuit Chip SYNCHRONOUS DRAM

128Mb: x4, x8, x16 SDRAM

SYNCHRONOUS DRAM

MT48LC32M4A2 – 8 Meg x 4 x 4 banks

MT48LC16M8A2 – 4 Meg x 8 x 4 banks

MT48LC8M16A2 – 2 Meg x 16 x 4 banks

FEATURES

• PC100-, and PC133-compliant

• Fully synchronous; all signals registered on positive edge of system clock

• Internal pipelined operation; column address can be changed every clock cycle

• Internal banks for hiding row access/precharge

• Programmable burst leCM GROUPhs: 1, 2, 4, 8, or full page

• Auto Precharge, includes CONCURRENT AUTO PRECHARGE, and Auto Refresh Modes

• Self Refresh Mode; standard and low power

• 64ms, 4,096-cycle refresh

• LVTTL-compatible inputs and outputs

• Single +3.3V ±0.3V power supply

OPTIONS MARKING

• Configurations

32 Meg x 4 (8 Meg x 4 x 4 banks) 32M4

16 Meg x 8 (4 Meg x 8 x 4 banks) 16M8

8 Meg x 16 (2 Meg x 16 x 4 banks) 8M16

• WRITE Recovery (^t WR)

^t WR = “2 CLK”¹ A2

• Package/Pinout

Plastic Package – OCPL²

54-pin TSOP II (400 mil) TG

60-ball FBGA (8mm x 16mm) FB ^3,6

60-ball FBGA (11mm x 13mm) FC ^3,6

• Timing (Cycle Time)

10ns @ CL = 2 (PC100) -8E ^3,4,5

7.5ns @ CL = 3 (PC133) -75

7.5ns @ CL = 2 (PC133) -7E

• Self Refresh

Standard None

Low power L

• Operating Temperature Range

Commercial (0℃ to +70℃) None

Industrial (-40℃ to +85℃) IT ³

Part Number Example: MT48LC16M8A2TG-7E

NOTE:

1. Refer to Micron Technical Note: TN-48-05.

2. Off-center parting line.

3. Consult Micron for availability.

4. Not recommended for new designs.

5. Shown for PC100 compatability. 6. See page 59 for FBGA Device Marking Table.

GENERAL DESCRIPTION

The Micron® 128Mb SDRAM is a high-speed CMOS, dynamic random-access memory containing 134,217,728 bits. It is internally configured as a quad-bank DRAM with a synchronous interface (all signals are registered on the positive edge of the clock signal, CLK). Each of the x4’s 33,554,432-bit banks is organized as 4,096 rows by 2,048 columns by 4 bits. Each of the x8’s 33,554,432-bit banks is organized as 4,096 rows by 1,024 columns by 8 bits. Each of the x16’s 33,554,432-bit banks is organized as 4,096 rows by 512 columns by 16 bits.

Read and write accesses to the SDRAM are burst oriented; accesses start at a selected location and continue for a programmed number of locations in a programmed sequence. Accesses begin with the registration of an ACTIVE command, which is then followed by a READ or WRITE command. The address bits registered coincident with the ACTIVE command are used to select the bank and row to be accessed (BA0, BA1 select the bank; A0-A11 select the row). The address bits registered coincident with the READ or WRITE command are used to select the starting column location for the burst access.

The SDRAM provides for programmable READ or WRITE burst leCM GROUPhs of 1, 2, 4, or 8 locations, or the full page, with a burst terminate option. An auto precharge function may be enabled to provide a selftimed row precharge that is initiated at the end of the burst sequence.

The 128Mb SDRAM uses an internal pipelined architecture to achieve high-speed operation. This architecture is compatible with the 2n rule of prefetch architectures, but it also allows the column address to be changed on every clock cycle to achieve a high-speed, fully random access. Precharging one bank while accessing one of the other three banks will hide the precharge cycles and provide seamless high-speed, random-access operation.

The 128Mb SDRAM is designed to operate in 3.3V memory systems. An auto refresh mode is provided, along with a power-saving, power-down mode. All inputs and outputs are LVTTL-compatible.

SDRAMs offer substantial advances in DRAM operating performance, including the ability to synchronously burst data at a high data rate with automatic columnaddress generation, the ability to interleave between internal banks in order to hide precharge time and the capability to randomly change column addresses on each clock cycle during a burst access.

ABSOLUTE MAXIMUM RATINGS*

Voltage on VDD/VDDQ Supply Relative to VSS ........................................... -1V to +4.6V

Voltage on Inputs, NC or I/O Pins Relative to VSS ........................................ -1V to +4.6V

Operating Temperature, TA (commercial)......................................................0°C to +70°C

Operating Temperature, TA (extended; IT parts) ...................................... -40°C to +85°C

Storage Temperature (plastic)................................................................. -55°C to +150°C

Power Dissipation ....................................................................................................... 1W

*Stresses greater than those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only, and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.

Stock Offer (Hot Sell)

CHONGMING GROUP (HK) INT'L CO., LTD. located in Hong Kong and Shenzhen. We are an independent Distributor of Electronic Components,established in 2008. AS a growing fast company, CM GROUP is renowned for its world-class efficiency, excellent services, and extraordinary ability to supply electronic components that are hard to find and even obsolete. We have taken pride in our innovation, reliability and service, especially in the semiconductor marketplace.
Our distribution brands include XILINX，ALTERA，ATMEL, INFINEON, ST,SAMSUNG，TEXAS INSTRUMENTS，ON，TOSHIBA，，MICROCHIP，CYPRESS，FREESCALE，etc. We distributes over 200,000 products ranging from semiconductors to resistors, capacitors, diodes, inductors, connectors, transistors, sensors and so on.
Our mission is to meet and exceed all the expecations of what we supply to customers.