Thread Port Electromagnetic Flow Transmitter DN15 Accurately Measuring

electromagnetic water flow meter, electromagnetic heat meter, thread port DN15

Description

Our new generation electromagnetic flow transmitter, with rugged, robust energy calculator that is ideal for commercial and industrial installations with a wide range of communication possibilities. It fulfils the IP67 requirements guarantee that the meter is resistant to dust, humidity and water, ensuring that no matter how hostile the conditions, the meter will continue accurately measuring.

The calculator can be read remotely using a wide variety of communication methods, some of which are in-built such as pulsed output and 4 analogue outputs.

It is a high end thermal energy calculator for industrial applications. Effectively protected against dust and humidity and backlit display. A wide range of built-in functions makes this energy meter a single box solution.

Measure theory

The flanged electromagnetic flowmeter for use in volumetric measurement of conductive fluid, like municipal or industrial water and waste water applications in which propeller meters have typically been used in the past. With no moving parts and electrodes designed to discourage fouling, the IYF magmeter require minimal maintenance in applications in which debris or sand would impede propeller meters. There is no rotor to stop turning or bearings to wear out.
It’s externally powered with 100-240VAC or 24 VDC. Low power requirements also make it ideal for solar and comparable power sources. Total indication is standard, as is a solid state pulse / frequency / 4-20mA output, that allows connection to a data logger. The display housing can be either integrated or remote. A shielded power/pulse output cable with DIN connection is included with the meter.

Features

• Virtually no pressure loss
• Suitable to meter for wide range of conductive liquid media
• No Moving Parts
• Flanges port connection
• RS485 Standard
• Suitable for Pipes diameter p to 2000 mm
• Large meter ratio
• High Accuracy
• 4 to 20 mA / Frequency / Pulse output

Technical data

Accuracy

Model selection

Notice on the selection of local type and remote type:

Remote type means the transmitter and converter display are mounted in different locations, it’s suggested to select
remote type in the following conditions:

• Ambient temperature or converter display sunshine temperature is over 60 ℃
• High humidity or corrosive air existed
• Serious pipe vibration
• Magnetic meter need be suspended or submersible, uneasily read out
• Other abrasive condition

Applicable metering liquid:

• Conductive liquid media, conductivity > 5 µS/ cm
• Various Conductive aqueous solutions, water solutions, acid & caustics
• Abrasive slurries, sludges and grease bearing liquids, corrosive liquid, municipal tap water, waste water,dirty
  water, effluent, fibrous, viscous, paper mill, food & beverage

Non-applicable metering medial

• Industrial gas, compressed air, steam, or liquid with large content of gas
• Liquid is non-conductive or low conductive, like lubricating oil, clean oil, cryogenic, cooling water, pure
  water, clean gas, etc.

Pipe Diameter, flow volume and product dimension

Industrial applications

Competitive advantage

• Compliance to international standards: ISO14001, GB/T28001, ISO9001-2008 / GB/T50430
• Strict process control
• Advanced calibration equipment
• Engineer team

Details demonstration

Inhouse PCB production Silicon steel transformer Calibration line

How to use the magnetic flow meter

The ElectroMagnetic flowmeters measure the velocity of conductive liquids in pipes, such as water, acids, caustic, and slurries. Magnetic flowmeters can measure properly when the electrical conductivity of the liquid is greater than approximately 5μS/cm. Be careful because using magnetic flowmeters on fluids with low conductivity, such as deionized water, boiler feed water, or hydrocarbons, can cause the flowmeter to turn off and measure zero flow.