

Add to Cart
Analog Data Record Conductivity Meter For Pure Water Ultra Pure Water
Conductivity controllers are widely used in thermal power, chemical
fertilizer, metallurgy, environmental protection, pharmaceutical,
biochemical, food and tap water industries. The controller mainly
continuously monitors the conductivity/total dissolved
solids/resistivity and temperature in the solution.
Specification:
Model | AEC1-C2D | |
Software Version | DRFN EC Analysis software V1.0 | |
Display Range | EC | 0.00~10.00 mS/cm (Full range automatic switching) |
Resistivity | 0.01Ω.cm~18MΩ.cm | |
TDS | 0.000mg/L~500g/L | |
Salinity | (0.00~10.0)% | |
Display Range(Temp) | -10~150℃ /14~302℉ | |
Resolution | EC | 0.01µS /cm |
Resistivity | 0.01Ω.cm | |
TDS | 0.001mg/L | |
Salinity | 0.1℃/ 0.1℉ | |
Accuracy | 0.1% of the measuring range | |
Stability | 0.05% of the measuring range every 24 hours, no accumulation | |
Repeatability | 0.1% better than the measuring range | |
Temperature Compensation | Automatic or manual(NTC10K or PT1000) | |
Relay Output | Two SPST relays, maximum load 3A/250VAC | |
Communication | RS485 Modbus RTU | |
Signal Output | Two 0/4~20mA current outputs maximum load 1000Ω | |
Sensor Diagnosis | Image display | |
Time history/data record | —— | |
Maintenance records | —— | |
Configuration | Power failure protection, indefinite retention of parameters | |
Language | Chinese and English | |
Display | 128*64 3.2-inch large graphic dot matrix LCD | |
Protection Grade | IP66 | |
Enclosure Material | Enhanced ABS | |
Power Supply | DC:18~36V | |
Dimension | 100*100*120mm | |
Hole Size | 92*92mm | |
Operating Temperature | 0~60℃, RH<95%, non-condensing | |
Storage Temperature | -20~70℃, RH<55%, non-condensing | |
Installation Method | Panel | |
Weight | 500g | |
Power Consumption | 3W |
Please click the user manual of conductivity controller here:
Delfino Conductivity Controller Manual.pdf
Brief introduction:
● 3.2-inch large LCD screen;
● User-friendly Chinese and English language interface;
● Password can be set to prevent misoperation;
● 2 SPST multi-function and settable relays;
● Two 0/4~20mA active current loop outputs;
● RS485 interface, Modbus RTU communication protocol;
● Temperature detection and compensation function;
● Shortcut button of AEC1 helps you perform daily maintenance
quickly;
● IP66 waterproof level, sealed enclosure can isolate pollution and
corrosive gas;
● Two dimensions, can meet a variety of installation methods, and
provide the necessary installation accessories at the same time.
Aplication:
◇ Pure water ultra pure water
◇ drinking water
◇ Waste water
◇ Food and beverage industry
◇ chemical process
◇ Industrial water supply
FAQ
1. Which sensors can be connected to your EC controller?
A: The EC meter can be compatible with DRFN EC sensors.
2. The EC controller can provide resistivity, TDS, salinity and other related conductivity?
The controller can also provide parameters such as resistivity, TDS, salinity and other related conductivity.