Mindray IMEC10 Patient Monitor parts Power Supply Board KB26Q5463 009-002108-00-2.0

Brand Name:Mindray
Model Number:KB26Q5463 009-002108-00-2.0
Delivery Time:3-5 working days
Payment Terms:T/T(wire transfer), Western Union, Paypal
Packaging Details:Carton
Product Name:Mindray IMEC10 Patient Monitor Power Supply Board KB26Q5463 009-002108-00-2.0
Contact Now

Add to Cart

Verified Supplier
Location: Guangzhou Guangdong China
Address: TianHe District,GuangZhou,GuangDong
Supplier`s last login times: within 33 hours
Product Details Company Profile
Product Details

Mindray IMEC10 Patient Monitor Power Supply Board KB26Q5463 009-002108-00-2.0


AC and DC power supply board


The power supply board is located on a metal sheet in the battery compartment on the bottom of the monitor. The power supply converts incoming AC power (100-240 VAC, 50/60 Hz) to a VIN bus voltage of 15.2 V and serves as the power source for all monitor voltages. The AC/DC power supply board supplies power to all modules via a 2-pin power cable on the connection board.


Connection card (DC/DC, power management circuit)


Breakout board for sending signals from external connectors and DC/DC power management circuits


  • DC-DC: Output 12V (10.8-12.6V), 5V +/- 5%.
  • Power management and ports
  • DC/DC conversion circuit
  • Charge and discharge management of single-cell lithium batteries
  • On/Off control: no delay on power on, no delay on power off
  • Battery type detection (current large capacity lithium battery and small capacity lithium battery)
  • On-site battery test
  • Battery voltage (capacity) detection.
  • Track on AC or battery power
  • Temperature control
  • Communicate with the motherboard
  • External port signal transmission (RJ45, USB, multi-function port, VGA)

Power Supply Specifications


AC power
Line voltage100 to 240 VAC (±10%)
Current1.1 to 0.5 A
Frequency50/60 Hz (±3Hz)

Power On/Off Failures

SymptomsPossible CauseCorrective Action

The patient monitor fails to start: AC LED, power on/off LED or battery LED does not light


AC mains not connected

or battery too low


Check that AC mains is properly connected or

battery capacity is sufficient


Cables defective or

to start: AC

poorly connected


1. Check that the cables from power switch & LED board to button board, button board to main board, power board to interface board, and interface board to main board are correctly connected.

2. Check that cables and connectors are not

damaged


Power switch & LED board defectiveReplace the power switch & LED board
Power board defectiveReplace the power board
Interface board defectiveReplace the interface board.
Mother board DefectiveReplace the mother board

Removing the Power Board


1. Disconnect the cable for AC input receptacle. Remove the three M3X6 screws indicated below and remove the power board

NOTE

Follow the instructions and unscrew the correct screws.



Thank you so much for your attention .If you're interested in Mindray IMEC10 Patient Monitor Power Supply Board KB26Q5463 009-002108-00-2.0 ,feel free to contact us .Thank you .


China Mindray IMEC10 Patient Monitor parts Power Supply Board KB26Q5463 009-002108-00-2.0 supplier

Mindray IMEC10 Patient Monitor parts Power Supply Board KB26Q5463 009-002108-00-2.0

Inquiry Cart 0