Max. 100A Switch Life Tester IEC 60884-1 Figure 12 Screwless Terminals Deflection And Voltage Drop Test Device
Brand Name:Sinuo
Certification:Calibration Certificate(cost additional )
Model Number:SN2112
Minimum Order Quantity:1 Set
Delivery Time:30 days
Payment Terms:L/C, T/T
Contact Now
Add to Cart
Verified Supplier
Location:
Guangzhou Guangdong China
Address:
Room 101, 1st Floor, No. 6, Third Street, Pingshan Industrial Zone 511495, Shibi Street, Panyu District, Guangzhou, China
Supplier`s last login times:
within 36 hours
Product Details
Company Profile
Product Details
IEC 60884-1 Figure 12 Screwless Terminals Deflection and Voltage Drop Test Device
Standard: IEC60884-1 clause 12.3.12, Figure 12.
Application: It is used to check screwless terminals shall be so designed that the connected rigid solid conductor remains clamped, even when it has been deflected during normal installation, for example, during mounting in a box, and the deflecting stress is transferred to the clamping unit.
Test sample: Plugs and socket-outlets screwless terminals.
Technical Parameters:
| Parameters Name | Parameter Data |
| Power supply | Match client's local power supply conditions |
| Deflection angle | 0-360° |
| Deflection direction | In any of the 12 directions differing from each other by 30°±3° |
| Deflection force | 0.25N, 0.5N, 1.0N |
| Force applied direction | Perpendicular to the undeflected conductor |
| Test current | Max.100A |
Sample installation:
1. Two insulation layer peeled solid conductors (about 150 mm) are
separately inserted into both ends of the screwless terminals,
shown as following:
2. Placed the screwless terminals into the fixture, the
perpendicular of the conductor should be coincided with the center
of the base. The upper conductor passes through the holes of the
force plate, the lower conductor should not touch the floor , then
clamp the terminal parts.
3. Loose the fastening handle of the support column and move the
crossbar up and down, so that the distance from the end of the
terminal to the force plate is 100 mm. The crossbar must be kept
horizontal.
4. The red clip of the current output of the voltage drop tester is clamped on the upper conductor, and the red clip of the voltage drop measurement input is clamped in the position near the terminal, then hang on the weight.
5. clamped on the lower conductor, and the black clip of the voltage drop measurement input is clamped in the position near the terminal.
6. Rotate the base turntable, each rotation is 30 °, the starting point should be where the conductor in a natural state.
Max. 100A Switch Life Tester IEC 60884-1 Figure 12 Screwless Terminals Deflection And Voltage Drop Test Device
Inquiry Cart
0