IEC 62196-3 Electric Vehicle Pressure Leak Test Overpressure Test System
Brand Name:Sinuo
Certification:Calibration Certificate (Cost Additional)
Model Number:SNQC1016
Minimum Order Quantity:1
Delivery Time:30 Days
Payment Terms:T/T
Contact Now
Add to Cart
Verified Supplier
Location:
Guangzhou Guangdong China
Address:
Room 101, 1st Floor, No. 6, Third Street, Pingshan Industrial Zone 511495, Shibi Street, Panyu District, Guangzhou, China
Supplier`s last login times:
within 36 hours
Product Details
Company Profile
Product Details
IEC 62196-3 Electric Vehicle Pressure Leak Test Overpressure Test System
Product Information For Overpressure Test System:
This overpressure test system meets the test requirements of IEC 62196-3-1 Cl 101.6. It is used to carry out pressure leakage test on the sealing requirements of the liquid coolants under 10L volume.
The system's booster pump outputs high pressure to verify the pressure resistance of the samples according to the different pressures of the samples. The system is composed of electrical control system, pressure control system and water tank, the workpiece is manually installed and connected.
Technical Parameters For Overpressure Test System:
| Power supply | AC 220V, 60Hz, 0.3KW |
| Test station | Single station |
| Electrical control method | Computer intelligent control and operation |
| Test pressure | 1.0-10.0Bar, booster pump drive |
| Pressure control accuracy | +1% of the upper limit of the test pressure value, -1% of the lower limit |
| Display accuracy | 0.1 Bar |
| Test medium | Dry air |
| Pressure control method | Computer control |
| Boost rate | Adjustable, non-uniform linear |
| Pressure hold time | 0-9999s arbitrarily set, with seconds as the time unit, computer display |
| Test process | Boost-hold-relief |
| Drive air pressure | 0.2-0.8MPa |
| Volume size | Less than 10L |
| Water tank dimensions | WDH=500×500×1000mm With transparent viewing window for observe bubbles |
| Standard output Interface | ZG1/4 internal thread User should consider the connection between our ZG1/4 internal thread to tests samples |
| Pressure curve display | Real-time display, data collected by software |
| Test data storage | Can save reports in excel form |
| Computer | Intel i5 4 G memory (or above) 512G SSD,Windows7 operating system and OFFICE processing software, with RS232 communication interface |
| Safety protection | |
| Power | Leakage protection, overload and short circuit protection |
| Motor | Overload, short circuit protection |
Precautions For Overpressure Test System:
1. Operators should carefully read the product instruction manual before using this equipment, master the knowledge of electricity safety, and take corresponding safety precautions; this test can only be carried out after confirming that there are no potential safety hazards.
2. During the test, the sample must be placed in the water tank to prevent the explosion caused by the sample being unable to withstand the high pressure and causing unnecessary damage to personnel.
3. Release the pressure in the gas storage tank when it is not in use for a long time.
4. Regularly open the ball valve at the bottom of the gas storage tank to discharge the water in the gas storage tank.
IEC 62196-3 Electric Vehicle Pressure Leak Test Overpressure Test System
Inquiry Cart
0