

Add to Cart
PP Microfiber/ Fiber Monofilament For Mortar Projects And Fine Aggregate Concrete Projects
PP Microfiber/ Fiber Monofilament Introduction:
Briture PP Microfiber/ Fiber Monofilament 110F is made of 100%
virgin homopolymer polypropylene with form of monoflament type, it
is mainly used for concrete and motar reinforcement,anti-cracking.
PP Microfiber/ Fiber Monofilament Features:
1. PP Microfiber/ Fiber Monofilament easy to disperse in mortar and concrete, and enhance the crack resistance of concrete
2. PP Microfiber/ Fiber Monofilament easy to operate, just put the fiber into the mortar mixture, add water and stir for a while.
3. Dosage: The dosage can be reduced (about 0.6ka/ m3).
4. Easy to plaster. Because a large number of fine fibers are evenly distributed in the mortar, it makes plastering easier, thus improving the bonding strength between the surface and the base.
5. Stable chemical properties, strong acid and alkali resistance, can be used for any engineering project.
PP Microfiber/ Fiber Monofilament Application:
1.For water-proof layer, floor, inner &outer wall of industrial
and civil construction.
2.Increase cracking resistance on the surface of industrial workshop, warehouse and parking lot.
3. Increase cracking & seepage resistance of the ground in natatorium, swimming pool, pond and ditch.
4.For any mortar projects and fine aggregate concrete projects.
PP Microfiber/ Fiber Monofilament Specification:
Raw material | 100% virgin PP |
Crack Elongation | 15-20% |
Diameter | 30+/-5 microns |
Melting Point | 160-170 |
Tensile Strength | > 500Mpa |
Elastic Modulus | >4500Mpa |
Length | 6mm, 12mm, 18mm... |
Acid & Alkali Resistance | strong |
Density | 0.91 |
Fiber Type | Monofilament (Microfiber) |
Melting Point(℃) | 160—170 |
Certificate: