Add to Cart
Oil Gas Station Explosion Proof Fluorescent Tube Light Corrosion Proof Led Light
Introduction
1. Suitable for zone 1 and zone 2 of explosive gas environment;,
2. Suitable for IIA.IIB explosive gas environment:
3. It is suitable for the environment where the temperature group
is T1~T6; it is equipped with T8 two-foot fluorescent tubes;
4. Suitable for explosive and dangerous environments such as
petroleum extraction, storage, chemical industry, medicine,
military industry and military facilities.
Features
1. Aluminum alloy die-casting shell, the surface is high-voltage
electrostatic spray;
2. High-strength toughened glass transparent tube;
3. Stainless steel exposed fasteners;
4. The lamp is equipped with a grille to increase the light
efficiency of the lamp and effectively reduce the glare;
5. Equipped with well-known brand fluorescent tubes, long life and
high luminous efficiency;
6. Modular plug-in design, you only need to loosen the end cap and
pull out the core to replace the lamp;
7. The fluorescent lamp with emergency device automatically
switches to the emergency lighting state when the power supply line
loses power;
8. There are specially designed overcharge and overdischarge
protection circuits in the emergency device;
9. Steel pipe or cable wiring.
Installation and maintenance
1. The sealing ring of the lead-in device should be reliably
pressed and the cable clamped;
2. The extra unused inlets on the junction box matched with the
lamp should be reliably sealed with a plugging plate and a
compression nut to ensure explosion-proof performance and
protection level performance;
3. Before the lamp is put into use, the internal and external
grounding must be firmly and reliably connected to the user's site
grounding system;
4. When installing and maintaining the lamp, it is strictly
forbidden to open it with power;
5. Regularly check the sealing ring, if it is found to be aging, it
should be replaced in time.
Technical Specification:
1 Compliance with:GB 3836.1,GB 3836.2,GB 3836.3,GB 12476.1,IEC60079-0,IEC60079-1 |
2 Explosion Protection: Exd IICT6 Gb / DIPA20TA, T6 |
3 Rated Voltage: AC 220V |
4 Tube options: T5/T8 Bi-pin fluorescent tubes(1*9W,2*9W,1*18W,2*18W,1*40W,2*40W) |
5 Ingress Protection:IP66 |
6 Corrosion Resistance:WF1 |
7 Cable Entries specification:2-G1/2 |
8 Cable’s outer dia.:Φ6mm~Φ10mm |
9 Charging time ≤24h |
10 Emergency starting time:≤0.3s |
11 Emergency lighting duration: ≥120min |