work hardening steel

Bushings Common Mechanical Part Reduce Wear And Friction bushings Key Attributes name Bushings Common Mec...

...wear resistance, but the impact toughness is poor characteristics. Applicaiton: D3 / Cr12 / 1.2080 is widely used cold die , wit...

... and good wear resistance, but poor impact toughness. A high carbon high chromium noted for its resistance to abrasion, it offe...

... Wear Resistant Bushings Rolled Thin Wall Metal Bushings Rolled thin wall bushing is formed by stamping and rolling a low-carb...

... bushings are designed according customer need with different kind of internal grooves providing lubricant distribution and abrasive particle...

17-7PH Cold Work Hardened Stainless Steel Strip In Coil AMS 5528 17-7PH, 631 is a precipitation hardening, austenitic stainless steel of the 17Cr-7Ni ...

... chromium alloy tool that replaces O1 tool when safer , less distortion and increased wear resistance are required. ...

... gear round bar VANFORGE supply hot- alloy, carbon and carbon-boron s in a variety of compositions and sizes. Hardenabilit...

..., GB Description: Type 201 stainless (UNS S 20100) is a low nickel, high-, austenitic chromium-nickel-manganese stainless ...

... Die Mold Plate Description (5) The advantage of repair welding is that the preheating and post-heating temperatures are lower than those...

... Bushings INW-307 , Sleeve Bushings Technical Data: Specific load capacity static≤ 250 [N/mm2] Specific load capacity dynami...

...304HC 316L​ Soft Stainless Cold Heading Wire High Machi­nability What is stainless cold heading wire? Stainless wi...

... Sheet AISI321 DIN1.4541 Delivery State Bright Surface Cut Edge Material Grade 304,304L,309S,310S,316,316Ti,317,317L,321,347,347...

...factory, the samples will be ready in 5-10 days; If the mould is not existing, we need to open a new mould, the samples will be ready in 10...

... Tool Manufacturer For Hot ing Mold H11 is one of the three most commonly used hot die , the carbide in the ste...

... with a apex angle of 40°. The tip should be rounded with radius of 0.25 mm ± 0.02 mm. The pin should with abration reistance t...

... 17-7PH/631 Stainless Nickel Alloy Cold Drawn Bar 1 . Descriptions: 17-7 PH stainless is a precipitation stainl...

...produced by carbon with oil groove,the initial grease given can be deposited the mass lubrication for long time .The surface can ...

...Advanced inspection apparatus 5. Condition: Chrome plated, Quenched / Tempered, Induction , Q / T Induction 6. Case depth:1.5mm - ...

Precision Machining Forged Steel Spiral Rod , Hardened Steel Shaft Description: We can produce 24 different kinds of sizes spiral rods. It is a shaft ...